Mill tooling

From ATXHackerspace

Revision as of 13:15, 9 April 2020 by Jon (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This tool is no longer at ATXHS

This page is for historical purposes only. If you are interested in a replacement for it, bring the discussion up on the atxhs-discuss mailing list.



The mill is an old Van Norman #16 with minimal tooling. It could use:

A full set of tie-downs (had some with it, but not a full set):

 http://www.harborfreight.com/58-piece-combination-step-block-and-clamp-set-3-8-eighth-inch-16-nc-studs-1-2-half-inch-clamps-5952.html

A boring head:

 http://www.harborfreight.com/2-inch-boring-bar-head-33562.html

Milling bits, boring bars, etc.